*NEW PRODUCTS*

Tal-Ko Exhaust Cradle Flate Connector 50mm Long Plate. Fits 2007 Tal-Ko Model Chassis Onwards. Zinc Plated Flat Steel

Tal-Ko Veloce Stub Axle Steel Spacer for Right Height Adjustments. For M10 Kingpin with One Side Flat to be placed to chassis frame and 14.3mm Thick with 28mm O/D.
This thicker spacer replaces 3 of the other spacers when all put together giving not only an easier assembly but also a more rigid and lighter setup than the three multiple spacers it replaces.

Tal-Ko Veloce Stub Axle Steel Caster Sperical Bush for M10 Kingpins. Has smaller I/D Bore to fit snug on M10 Kingpin bolts.

Tal-Ko Veloce Stub Axle Steel Caster Fixed Central with No Holes for Adjustments. Fits all Veloce model karts from 2020 with 22.4mm Dia Hole or modified older models to take this larger diameter fit. Has a groove on outside to denote new larger fit diameter to chassis.

R/R Speed Evo Rear Brake Pad Steel Shim 2.0mm Thick.
This shim can be used to prevent caliper pistons sticking out too far when brake pads are worn.

R/R Speed Evo Rear Brake Pad Steel Shim 1.5mm Thick.
This shim can be used to prevent caliper pistons sticking out too far when brake pads are worn.

R/R Speed Evo Rear Brake Pad Steel Shim 0.9mm Thick.
This shim can be used to prevent caliper pistons sticking out too far when brake pads are worn.

R/R Speed Evo Rear Brake Pad Steel Shim 0.5mm Thick
This shim can be used to prevent caliper pistons sticking out too far when brake pads are worn.

CRG NA2 / NA3 2018 Front Top Bumber. Has a wider lower rail for great contact with plastic blocks and snap clamps.

Tal-Ko Exhaust Cradle Flate Connector 50mm Long Plate Conversion Kit for Fits 2007 Tal-Ko Model Chassis Onwards. Silver Zinc Plated Flat Steel.
Come with 1 off M8 x 35 CSK Bolt, 1 off M8 x 55 CSK Bolt, 1 off M8 Nyloc Nut & 1 off M8 Black Anodised Flared Washer.

FLEX SLEEVE for Exhaust 40mm Long. Fits TAG Exhaust . SILICONE COATED, WOVEN INSULATED GLASS FIBRE, HIGH TEMP Best Quality. Must be carefully secured at each end with BTSLTW ties to prevent splitting. Over stretching of this sleeve will damage it. Make sure on the larger flex TAG exhausts that the sleeve is fitted so that the sleeve is at least 10mm clear of spring ends on exhaust pipe side or damage/splitting will occur.

FLEX SLEEVE for Exhaust 120mm Long. Fits TAG Exhaust . SILICONE COATED, WOVEN INSULATED GLASS FIBRE, HIGH TEMP Best Quality. This sleeving must carefully be cut to length (should get 3 pieces per length) using sharp long scissors and secured at each end with BTSLTW ties to prevent splitting. Over stretching of this sleeve will damage it. Make sure on the larger flex TAG exhausts that the sleeve is fitted so that the sleeve is at least 10mm clear of spring ends on exhaust pipe side or damage/splitting will occur.